在 2026 年的求職市場上，H3C 認證依然是企業辨識專業能力的重要依據。想順利取得 H3CSE-RS-SW 認證，KaoGuTi 的 GB0-372-ENU 題庫是值得信賴的備考工具。

H3C GB0-372-ENU 考試概覽:

認證廠商:	H3C
考試名稱:	H3CSE-RS-SW 認證考試 (路由與交換)
考試代碼:	GB0-372-ENU
相關認證:	H3CSE H3CIE H3CNE
支援語言:	English
考試形式:	單選題, 多選題
範例考題:
考試方式:	透過授權測試中心或線上監考平台進行的電腦化考試
必備條件:	建議具備相當於 H3CNE 或類似認證的網路基礎知識

H3C GB0-372-ENU 考試大綱主題:

關於 GB0-372-ENU 考試，考生最常問的問題

最新的 H3CSE-Routing & Switching GB0-372-ENU 免費考試真題：

問題 #1

Contrast the calculation convergence of RSTP and STP. Which of the following statements is correct? (Multiple choice)

A. Compared with STP, RSTP defines edge ports, which can make the ports connected to the i machine quickly enter the forwarding state
B. Compared with STP, STP defines a fast root port switching mechanism, which allows the Alternate to quickly become the new root port.
C. Compared with STP, STP defines a fast switch mechanism for designated ports, which allows the designated port to quickly enter the forwarding state without waiting for twice the Forward Delay time.
D. If STP wants to shorten the convergence time, it can only configure a smaller ForwardDelay time, but this may affect the stability of the network.

問題 #2

Which of the following addresses is not an IPv4 multicast address?

A. 242.255.255.250
B. 224.0.0.13
C. 232.255.255.255
D. 239.255.255.255

問題 #3

A customer wants to deploy 802.1X in the local area network to improve access security. In addition to configuring the initial VLAN to which the port belongs on the 802.1X access device, the customer also wants to configure the Guest VLAN on the port with the access control method of port based. Which of the following is the correct description of this solution? (Multiple choice)

A. If the user fails authentication, he can only access resources in the Guest VLAN
B. If the user authentication is successful, the port will leave the Guest VLAN
C. If the user fails authentication, he can only access the resources in the VLAN that the user initially configured.
D. If the user authentication is successful, the user may return to the initially configured VLAN

問題 #4

As shown in the figure, SWA and SWB enable STP, and SWC does not enable STP. Initially, link 2 is not connected, and PCB can send data to PCA. If link 1 fails at this time, the maintenance personnel connect link 2. Which of the following statement about the recovery process of data transmission from PCB to PCA is (assuming that PCA will not actively send data) is correct?

A. Service recovery requires waiting for the MAC address of the SWC to age, so the default time is 300 seconds.
B. Since the SWA link interruption will trigger the topology change process, the MAC address aging time of SWA and SWB will be shortened, so the service recovery takes 15 seconds by default.
C. Since SWB port EO/1 takes 30 seconds to enter the forwarding state by default, the service takes 30 seconds to recover by default.
D. When SWB port EO/1 enters the Forwarding state, it triggers the topology change process, so the service will eventually recover in the default time of 30+15=45 seconds.

問題 #5

In the switching network shown in the figure, VLAN10 is set as Isolate-user-vlan on switch SWA, VLAN2 and VLAN3 are set as Secondary VLAN of VLAN 10; VLAN4 and VLAN20 are created on switch SWB, and VLAN20 is set as Isolate-user-vlan, and VLAN4 is set as Secondary VLA of VLAN20. After setting the IP addresses of each device as shown in the figure, if the local proxy ARP function is enabled on SWA and SWB, and SWA and SWB are allowed to send ICMP packets, then execute the command tracert 10.1.1.2 on PCA, and PCA will display the jumps required to reach PCB ()

問題與答案：